Speedometer; Odometer - Subaru Impreza 2016 Manual

3-10
Instruments and controls/Meters and gauges
2. Press the trip knob to show
on the trip meter display.
The display can be switched as shown in
the following sequence by pressing the
trip knob.
1
* : They cannot be displayed when the
ignition switch is in the ON position.
2
* : MT models without gear shift indicator
only
To change the current setting, press the
trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle's initial movement
setting of the meter/gauge needles
has been set for activation "
the time of shipment from the factory.
. It is not possible to change the
or movement setting of the meter/gauge
needles when the ignition switch is in
the "ON" position. Change the setting
when the ignition switch is in the
"LOCK"/"OFF" or "ACC" position.
! Type B combination meter
Perform the procedures described in
Gauge Initial Movement F3-50.
& Speedometer
The speedometer shows the vehicle
speed.
! Speed warning chime (if equipped)
When the speed is over approximately
120 km/h (75 mph), a chime sounds.
" at
& Odometer
Type A
1) Trip knob (left-hand drive models)
2) Trip knob (right-hand drive models)