Speedometer; Odometer - Subaru Crosstrek 2016 Owner's Manual

3-10
Instruments and controls/Meters and gauges
The display can be switched as shown in
the following sequence by pressing the
trip knob.
*: They cannot be displayed when the
ignition switch is in the ON position.
To change the current setting, press the
trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle s initial movement
setting of the meter/gauge needles
has been set for activation
the time of shipment from the factory.
. It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the ON position. Change the setting
when the ignition switch is in the
LOCK / OFF or ACC position.
Type B combination meter
Perform the procedures described in
Gauge Initial Movement

Speedometer

The speedometer shows the vehicle
speed.

Odometer

at
Type A
1) Trip knob
3-41.
Type B
1) Trip knob (U.S.-spec. models)
2) Trip knob (except U.S.-spec. models)
This meter displays the odometer when
the ignition switch is in the ON position.
The odometer shows the total distance
that the vehicle has been driven.
If you press the trip knob when the ignition
switch is in the LOCK / OFF or ACC
position, the odometer/trip meter will light
up. If you do not press the trip knob within
10 seconds of illumination of the od-
ometer/trip meter, the odometer/trip meter
will turn off.
Also, if you open and close the driver s
door within 10 seconds of illumination of
the odometer/trip meter, the odometer/trip
meter will turn off.