Table of Contents
Advertisement
Additional cooling
Before the end of the program, the
temperature of the dried laundry is
monitored and the cooling phase at
the end of the program is extended if
necessary.
Changing this setting leads to increased
energy consumption.
– Factory default: Off
– On
Cooling down temperature
The laundry will be cooled down
automatically before the end of the
program. The automatic cooling-down
phase which takes place before the
end of a program can be set at a
cooler level for all programs. This
means that the cooling phase is
extended.
Changing this setting leads to increased
energy consumption.
The setting can be changed from
104-131°F (40°C–55°C).
Factory default: 131°F (55°C)
Supervisor level
Service
Clean out the airways
The tumble dryer's electronic
calculates the degree at which lint or
detergent residue in the lint filters and
air ducts are impairing performance. A
message to check the contamination
appears. You can decide at what level
of lint this reminder should be emitted.
This prompt, which you can configure,
is displayed:
Clean out the airways
– Off
The reminder does not appear.
However, if there is a very severe
blockage in the ducting, the program
will be canceled and the reminder will
appear in the display regardless of
this option.
– Heavy
The reminder only appears when
there is a heavy build-up of lint.
– Factory default: Normal
– Sensitive
The reminder appears when there is
only a small build-up of lint.
85
Advertisement
Table of Contents
