WEIDER CLUB C725 User Manual page 25

48. Wrap the High Cable (81) over a Small Pulley
(74). Insert the Small Pulley and the Cable into
the remaining Bracket Guard (149); make sure
that the Cable is under the indicated rod. Next,
attach the Bracket Guard and the Small Pulley
inside the Swivel Bracket (31) with an M10 x
60mm Button Bolt (136), two M10 Washers (83),
two Pulley Caps (73), two 6.5mm Spacers (100),
and an M10 Nylon Locknut (116) as shown.
Next, attach an M6 x 48mm Button Bolt (124) and
an M6 Nylon Locknut (150) to the Swivel Bracket
(31) and the Bracket Guard (149). Make sure
that the High Cable (81) is between the Button
Bolt and the Small Pulley (74).
49. Identify the Rear Cable (94). Attach one end of
the Cable to the Weight Carriage (19) with an
M10 x 20mm Button Bolt (56) and an M10 Nylon
Locknut (116). Make sure that the end of the
Cable is turned so the flat side is against the
Weight Carriage as shown in the inset draw-
ing.
50. Route the Rear Cable (94) through the Weight
Carriage Frame (18) as shown. Wrap the Cable
over a Small Pulley (74). Attach the Small Pulley
inside the Weight Carriage Frame with an M10 x
65mm Button Bolt (66), two M10 Washers (83),
two 12.5mm Spacers (138), and an M10 Nylon
Locknut (116).
48
100
116
83
73
149
Rod
81
49
116
94
56
19
50
25
150
124
83
31
100
73
74
136
94
56
19
74
83
Slot
116
138
138
18
83
94
116
66