WEIDER CLUB C725 User Manual page 18

29. Identify the Right Arm (23) and insert it into the
Arm Frame (24). See the inset drawing. Make
sure that the welded pin on the Right Arm is
behind the rod on the Arm Frame as shown.
Apply grease to an M10 x 94mm Bolt (134).
Attach the Right Arm (23) to the Arm Frame (24)
with the Bolt and an M10 Thin Nylon Locknut
(86). Do not overtighten the Thin Nylon
Locknut; the Right Arm must pivot easily.
Next, press two Bushing Caps (88) onto the Bolt
and the Thin Nylon Locknut.
Next, slide an Arm Pad (89) onto the Right Arm
(23).
Attach the Left Arm (22) to the Arm Frame (24)
in the same way.
30. Attach the Center Backrest (69) to the Center
Upright (13) with two M6 x 65mm Button Screws
(126) and two M6 Washers (142).
31. Tighten three Weight Storage Tubes (67) onto the
Left Rear Upright (12).
Tighten the remaining three Weight Storage
Tubes (67) onto the Right Rear Upright (60).
29
23
89
30
69
31
60
67
18
88
134
Grease
24
86
88
22
View from back
24
23
Pin
Rod
126
142
13
126
142
67
67
12
67