WEIDER CLUB C725 User Manual page 23

44. Wrap the High Cable (81) under a Small Pulley
(74). Attach the Small Pulley, a Small Cable Trap
(93), and two Half Pulley Guards (91) to the sec-
ond hole from the top of the "U"-bracket (90) with
an M10 x 52mm Button Bolt (135) and an M10
Nylon Locknut (116). Make sure that the Small
Cable Trap and the Half Pulley Guards are ori-
ented as shown.
45. Wrap the High Cable (81) over a Small Pulley
(74). Next, remove the M10 Nylon Locknut (116)
attached in step 43. Slide the Small Pulley, a
Small Cable Trap (93), and an M10 Washer (83)
onto the M10 x 125mm Button Bolt (141) inserted
in step 43. Then, tighten the Nylon Locknut onto
the Button Bolt. Make sure that the Small Cable
Trap is oriented to hold the Cable in the
groove of the Small Pulley.
44
45
23
74
81
93
91
116
91
90
135
74
141
93
83
116
81