WEIDER CLUB C725 User Manual page 20

35. See the CABLE DIAGRAM on page 34 to iden-
tify the cables as you assemble them.
Identify the Arm Cable (82). Apply grease to an
M8 x 25mm Shoulder Bolt (143). Attach the Arm
Cable to the Left Arm (22) with the Shoulder Bolt
and an M8 Nylon Locknut (139). Make sure that
the end of the Cable is turned so the flat side
is facing downward as shown in the inset
drawing.
36. Identify the two "V"-pulleys (75), which are wider
than the other pulleys. Wrap the Arm Cable (82)
over a "V"-pulley. Attach the "V"-pulley, a Large
Cable Trap (77), and two Full Pulley Guards (76)
to the indicated bracket on the Center Upright
(13) with an M10 x 63mm Button Bolt (133), an
M10 Washer (83), and an M10 Nylon Locknut
(116). Make sure that the Large Cable Trap is
oriented to hold the Cable in the groove of the
"V"-pulley.
37. Wrap the Arm Cable (82) under a Small Pulley
(74). Attach the Small Pulley and two Half Pulley
Guards (91) to the Double "U"-bracket (98) with
an M10 x 45mm Button Bolt (131) and an M10
Nylon Locknut (116). Make sure that the Half
Pulley Guards are oriented as shown.
35
36
37
20
Grease
82
143
139
22
143
82
116
Bracket
76
75
13
133
77 83
76 82
82
74
116
91
98
91
131