WEIDER CLUB C725 User Manual page 15

21. Attach a Spotter Hook (115) to a Barbell Spotter
(109) with an M10 x 26mm Button Bolt (119) and
an M10 Nylon Locknut (116). Do not overtighten
the Nylon Locknut; the Spotter Hook must
pivot easily.
Next, slide a Barbell Spotter Bumper (111) and
the Barbell Spotter (109) onto the left Barbell
Guide (25). Engage the Spotter Hook (115) into
an adjustment slot near the bottom of the left
Front Upright (11).
Next, identify the Left Barbell Carriage (110),
which is marked with a sticker. Slide a Barbell
Bumper (107) and the Left Barbell Carriage onto
the left Barbell Guide (25).
Repeat this step on the other side. Always
position both Barbell Spotters (109) at the
same height.
22. Set the Top Frame (17) on the Uprights (11, 12,
60) and the Barbell Guides (25).
Attach the Top Frame (17) to the left Front
Upright (11) with two M10 x 92mm Button Bolts
(120), four M10 Washers (83), and two M10
Nylon Locknuts (116). Do not tighten the Nylon
Locknuts yet.
Attach the Top Frame (17) to the right Front
Upright (11) in the same way.
21
11
22
60
11
25
15
110
116
107
109
119
115
111
25
17
12
83
116
83
120
83
83
11
120
25