WEIDER CLUB C725 User Manual page 24

46. Wrap the High Cable (81) around a Small Pulley
(74). Attach the Small Pulley to the indicated
bracket on the Weight Carriage Frame (18) with
an M10 x 45mm Button Bolt (131) and an M10
Nylon Locknut (116).
47. See inset drawing A. Insert the cabling rod into
the left side of the Top Frame (17) as shown.
Attach the High Cable (81) to the cabling rod. Pull
the opposite end of the cabling rod until the Cable
is routed through the Top Frame. Then, remove
the cabling rod.
See inset drawing B. Apply grease to the left
Trunnion (70). Then, slide the remaining Swivel
Bracket (31) onto the High Cable (81) and the left
Trunnion. Next, orient a Swivel Bracket Bearing
(72) so that the slots are on the indicated side,
and slide it onto the end of the Cable. Then, tight-
en the Swivel Bracket Bearing into the Trunnion.
Wrap the High Cable (81) around a Small Pulley
(74). Attach the Small Pulley inside the Top
Frame (17) with an M10 x 70mm Button Bolt (97),
an M10 Washer (83), and a 25mm Spacer (121).
Press a Top Frame Cap (127) into the Top Frame
(17).
Remove the M8 Jamnut (53) from the High Cable
(81), and slide the Cable Stop (55) onto the
Cable. Next, tighten the Jamnut onto the Cable
as far as possible, tighten the Cable Eyelet (54)
onto the Cable as far as possible, and then tight-
en the Jamnut against the Cable Eyelet. Then,
slide the Cable Stop down onto the Cable Eyelet.
46
Bracket
116
47 A
B
Grease
81
Slots
72
17
81
55
53
54
24
131
18
74
81
17
Cabling
70
31
97
83
121
81
Rod
74
81
127