Figure 73
1. Feeler gauge
Figure 74
1. Feeler gauge
•
If the gap is less than 0.25 mm (0.01
inch), then install the shim and refer to
Using the Clutch Shim (page
•
If the gap is sufficient, proceed to the
safety check in step F.
F.
Perform the following safety check:
i.
Sit on the seat and start the engine.
ii.
Ensure that the blades do not
engage with the PTO switch in the
O
position, and that the clutch is
FF
disengaged.
If the clutch does not disengage,
install the shim again and refer to
Using the Clutch Shim (page
iii.
Engage and disengage the PTO
switch 10 consecutive times to
ensure that the clutch is functioning
properly.
Cooling System
Maintenance
Cleaning the Engine Screen
and Engine-Oil Cooler
g010872
Service Interval: Before each use or daily
Remove any buildup of grass, dirt, or other debris
from the oil cooler
g010873
50).
Before each use, remove any buildup of grass, dirt, or
other debris from the engine screen. This will help
ensure adequate cooling, correct the engine speed,
and will reduce the possibility of overheating and
mechanical damage to the engine
50).
52
(Figure
75).
Figure 75
(Figure
g008804
g009191
76).