Product Overview; Controls - Toro Z Master Professional 5000 Series Operator's Manual

Product Overview

1. Height-of-cut deck-lift
pedal
2. Transport lock
3. Parking-brake lever

4. Controls

5. Motion-control levers
Controls
Become familiar with all the controls before you start
the engine and operate the machine
Figure 5).
1. PTO Switch
2. Choke
3. Throttle control
Figure 4
6. Roll bar
7. Seat belt
8. Fuel cap
9. Mower deck
10. Caster wheel
(Figure 4
Figure 5
4. Hour
meter/Safety-interlock
display
5. Ignition switch
6. Fuses
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance
Fuel Gauge
The fuel gauge is located with the hour meter, and
the bars light up when the ignition switch is in the On
position (Figure
The indicator light appears when the fuel level is low
(approximately one gallon remaining in the fuel tank).
Safety-Interlock Indicators
There are symbols on the hour meter which indicate
g027333
with a black triangle that the interlock component is in
the correct position
Battery-Indicator Light
If the ignition key is turned to the O
seconds, the battery voltage will be displayed in the
area where the hours are normally displayed.
The battery light turns on when the ignition is turned
on and when the charge is below the correct operating
level (Figure
and
1. Fuel gauge (bars)
2. Battery light
g008951
3. Hour meter
Throttle Control
The throttle control is variable between F
S .
LOW
14
(Figure 6).
6).
(Figure 6).
N
6).
Figure 6
4. Safety-interlock symbols
5. Low fuel-indicator light
position for a few
g008950
and
AST