Specifications - Toro Z Master Professional 5000 Series Operator's Manual

Choke
Use the choke to start a cold engine. Pull the choke
knob up to engage it.
Blade-Control Switch (PTO)
Use the blade-control switch (PTO) is used to engage
the electric clutch and drive the mower blades. Pull
the switch up to engage the blades and release. To
disengage the blades, push the blade-control switch
(PTO) down or move a motion-control lever into the
- position.
NEUTRAL LOCK
Ignition Switch
This switch is used to start the mower engine and has
3 positions: S , R
TART UN
Motion-Control Levers
The motion-control levers are used to drive the
machine forward, reverse, and turn either direction.
Neutral-Lock Position
Use the -
NEUTRAL LOCK
safety-interlock system to engage and to determine
the position.
NEUTRAL
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
and O .
FF
position with the

Specifications

Note:
Specifications and design are subject to
change without notice.
Width
Without Deck
Deflector Up
Deflector Down
Length
Roll Bar - Up
Roll Bar - Down
Height
Roll Bar - Up
Roll Bar - Down
Weight
569 kg (1255 lb)
15
135 cm (53 inches)
157 cm (62 inches)
192 cm (76 inches)
211 cm (83 inches)
215 cm (85 inches)
179 cm (71 inches)
119 cm (47 inches)