Using The Safety-Interlock System - Toro Z Master Professional 5000 Series Operator's Manual

Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Let the engine idle at S
seconds before turning the key to the O
Figure 20
Important:
Ensure that the fuel-shutoff valve is
closed before transporting or storing the machine,
as fuel leakage may occur. Set the parking brake
before transporting. Ensure that you remove
the key as the fuel pump may run and cause the
battery to lose charge.
throttle (turtle) for 60
LOW
position.
FF
Using the Safety-Interlock
System
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
engine from starting unless:
•
The parking brake is engaged.
•
The blade-control switch (PTO) is disengaged.
•
The motion-control levers are in the N
position.
The safety-interlock system also is designed to shut
off the engine when you move the traction controls
from the position with the parking brake engaged
LOCK
or if you rise from the seat when the PTO is engaged.
The hour meter has symbols to notify you when the
interlock component is in the correct position. When
the component is in the correct position, a triangle
lights up in the corresponding square.
g027337
1. Triangles light up when the interlock components are in the
correct position.
23
EUTRAL
Figure 21
-
LOCK
g009181