Adjusting The Flow Baffle Cam Locks; Positioning The Flow Baffle - Toro Z Master Professional 5000 Series Operator's Manual

Adjusting the Flow Baffle
Cam Locks
This procedure is applicable only to machines with
the flow-baffle locks. Certain models will have nuts
and bolts in place of the flow-baffle locks and can be
adjusted the same.
The mower-discharge flow can be adjusted for
different types of mowing conditions. Position the cam
locks and baffle to give the best quality of cut.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. To adjust the cam locks, swing the lever up to
loosen the cam lock
4. Adjust the baffle and cam locks in the slots to
the desired discharge flow.
5. Swing the lever back over to tighten the baffle
and cam locks (Figure
6. If the cam locks do not lock the baffle into place
or it is too tight, loosen the lever and then rotate
the cam lock.
Note:
Adjust the cam lock until the desired
locking pressure is achieved.
Figure 29
-
NEUTRAL LOCK
(Figure 29).
29).

Positioning the Flow Baffle

The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and the height of the grass.
Note:
If the engine power draws down and the
mower ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for
this position is as follows:
•
Short, light grass mowing conditions
•
Dry conditions
•
Smaller grass clippings
•
Propels grass clippings farther away from the
mower
Position B
Use this position when bagging. Always align it with
the blower opening.
g027727
28
Figure 30
Figure 31
g005832
g005833