Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
Check that both the mounting hardware and the
knobs are in good working condition. Ensure that the
knobs are fully engaged with the ROPS in the raised
position. The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to get both
knobs fully engaged
(Figure
65).
1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position
Adjusting the Tracking
Refer to
Adjusting the Tracking (page
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
49
Figure 65
3. Roll bar in the upright
position
4. Roll bar in the folded
position
49).
g008943