Adjusting The Motion Control Neutral-Lock Pivot; Hydraulic System Maintenance; Servicing The Hydraulic System - Toro Z Master Professional 5000 Series Operator's Manual

Adjusting the Motion
Control Neutral-Lock Pivot
The flanged nut can be adjusted to obtain a more
desired motion-control lever resistance when moving
it to the -
NEUTRAL LOCK
adjustment options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired
feel.
Note:
For more resistance, tighten the flanged
nut.
Note:
For less resistance, loosen the flanged
nut
3. Tighten the jam nut.
Figure 87
1. Flanged nut
position. See Figure 87
2. Jam nut
Hydraulic System
Maintenance
Servicing the Hydraulic
for
System
Hydraulic Fluid Type: Toro
hydraulic fluid or Mobil
Important:
could cause system damage.
Each Hydraulic System fluid Capacity: 1.5 L (52
oz) per side with filter change
Checking the Hydraulic Fluid
Service Interval: Every 50 hours—Check the
1. Position the machine on a level surface.
2. Disengage the PTO, move the motion-control
levers to the
parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
g008621
operating position.
4. Allow the engine and the hydraulic system to
cool for 10 minutes.
Note:
incorrect when the fluid is checked and the unit
is hot.
5. Move the seat forward.
6. Clean the area around the dipsticks of
hydraulic-system reservoirs
7. Remove one dipstick from the hydraulic reservoir
(Figure
8. Wipe the dipstick off and thread the dipstick into
the reservoir.
9. Remove the dipstick and look at the end
88).
Important:
units with fluid as damage may occur. Do
not run the machine with the fluid below the
add mark.
10. If the fluid level is at the add mark , slowly pour
only enough fluid into the hydraulic reservoir to
raise the level to the full or H line.
11. Install the dipstick.
12. Repeat the procedure for the opposite dipstick.
59
® HYPR-OIL
® 1 15W-50.
Use the specified fluid. Other fluids
hydraulic fluid level.
- position, and set the
NEUTRAL LOCK
The fluid level on the dipstick will be
(Figure
88).
Do not overfill the hydraulic
™ 500
88).
(Figure