Tools - Extron electronics XMP 240 C AT User Manual

Tools

Figure 11.
Presets — Contains a submenu to mark and clear elements in the main workspace as
1
well as an option to save marked elements to a preset
Configure Groups — Opens the
2
delete Gain, Mute, Bass, Treble, Loudness, and Meter Groups
Configure Macros — Opens the
3
and deleting macro functions
Connect/Disconnect from Device — When in Emulate mode, this reads Connect to
4
Device and opens the Connect to Device dialog box (
from Device
and returns the software to Emulate mode.
Device Manager — Opens the
5
page 76).
Issue RESET Command — Clears the XMP 240 of all processors and other configuration
6
settings. This command does not reset general settings such as IP address.
Firmware Loader — Opens the Firmware Loader application, if it is installed (
7
Loader
Organize Building Blocks – Opens the
8
Building Blocks
9 Device Settings — Opens the
address, DHCP status, and other settings (
Options – Opens the
¢
settings, DSP value defaults, and so on (
Network Audio Control — Opens the Dante Controller application by Audinate for routing
£
audio over a Dante network (
¤ Expansion Bus — Contains a submenu to show that the XMP 240 is set as the primary unit
Expansion Bus
(
Tools Menu
Configure Groups
Configure Macros
(Macros
on page 78). When in Live mode, this reads Disconnect from Device
Device Manager
www.extron.com
on page 79). Visit
on page 82).
Device Settings
dialog box to configure DSP Configurator appearance, default
Options
Dante Controller
on page 88).
(Presets on page 67).
dialog box to create, edit, and
(Groups
dialog box for creating, editing,
on page 72).
Connect to or Disconnect
Device Manager
dialog box (
to download the software.
Organize Building Blocks
dialog box to edit date and time, IP
Device Settings
on page 83).
Options
on page 87).
on page 89).
XMP 240 C AT • DSP Configurator Software
on page 69).
on
Firmware
Organize
dialog box (
14