Table of Contents
Advertisement
Web Pages
This section describes web page operation and control of the XMP 240 C AT.
The XMP 240 C AT can be accessed by a PC or control system using a rear panel Ethernet
LAN port and a web browser such as Microsoft
factory-installed HTML pages and cannot be erased or overwritten.
NOTE: If the Ethernet connection to the device is unstable, try turning off the proxy
XMP 240 C AT Web Page
Accessing the Embedded Web Page
1.
2.
3.
server in the web browser. In Microsoft Internet Explorer, click
Options > Connections > LAN Settings
click
.
OK
From a web browser, enter the device IP address into the address field.
NOTE: If the local system administrators have not changed the IP address, and
the device has not been assigned an IP address via DHCP, the default address is
.
192.168.254.254
Press
. The device checks the password protection status, if a password is
<Enter>
required, enter the password in the
username is required.
The device checks several possibilities in the following order and responds accordingly:
a.
If the address includes a specific file name, such as
192.168.254.254/file_name.html
b.
If there is a file in the device memory named
as the default startup page.
index.html
c.
If a and b do not apply, the device downloads the factory-installed default startup
page,
nortxe_index.html
Internet Explorer. These web pages are
©
, uncheck the
Use a proxy server...
dialog box and press <
Connect to...
, the device downloads the web page.
index.html
, also known as the
System Status
XMP 240 C AT • Web Pages
Tools > Internet
, then
>. No
Enter
, the device downloads
page.
140
Advertisement
Table of Contents
