Programming Start And Stop Of The System With Timer - Daikin VRV II Series Design, Installation & Testing Instructions

Si39-303
6.4

Programming Start and Stop of the System with Timer

!
!
!
RXYQ series
!
Notes:
!
!
For example:
When the timer is programmed to stop the system after 3 hours and start the system after 4
hours, the system will stop after 3 hours and start 1 hour later.
RXYQ series
Operation Manual
The timer is operated in the following two ways.
Programming the stop time "
elapsed.
Programming the start time "
elapsed.
The timer can be programmed for a maximum of 72 hours.
The start and the stop time can be simultaneously programmed.
Press the timer mode start/stop button several times and select the mode on the display.
1
The display flashes.
• For setting the timer stop "
• For setting the timer start "
Press the programming time button and set the time for stopping or starting the system.
2
Each time this button is pressed, the time advances or goes backward by 1 hour.
Press the timer on/off button.
3
The timer setting procedure ends. The display "
flashing light to constant light.
When setting the timer off and on at the same time, repeat the above procedure (from "
to " ") once again.
3
After the timer is programmed, the display shows the remaining time.
Press the timer on/off button once again to cancel programming. The display vanishes.
". The system stops operating after the set time has
". The system starts operating after the set time has
REYQ series
"
"
" or "
REYQ series
Operation Procedure
" changes from
"
1
211