Installation
WHEN ELECTRIC WIRING WORK IS NOT FINISHED
!
!
!
42
Remove the electric parts box lid, connect a power supply and remote controller to the terminals. (Refer
to the How to CONNECT WIRINGS (Refer to Installation Manual))
Next, press the inspection/test operation button "
the test operation mode. Press the operation mode selector button "
OPERATION "
". Then, press the ON/OFF button "
start up. Check that the water has drained from the unit. Press "
You can check whether drainage is satisfactory or not by removing the access opening lid and checking
the water level of the drain pan through the access opening.
Be careful when doing so because the fan is turning at the same time.
" on the remote controller. The unit will engage
" until selecting FAN
". The indoor unit fan and drain pump will
" to go back to the first mode.
General Information
Si39-303