Table of Contents
Advertisement
TROUBLESHOOTING
Monitoring Beeper Coded Signals
CODED SIGNALS
2 short beeps
(when engine is started).
DESS/RER pilot lamp
also blinks.
1 short beep every
1.5 seconds
(when engine is started).
DESS/RER pilot lamp
also blinks. Engine
cannot reach pulley
engagement speed.
Vehicle cannot be driven.
1 long beep per second. Reverse is
3 short beeps per
second. DESS/RER pilot
lamp also blinks. Engine
cannot reach pulley
engagement speed.
Vehicle cannot be driven.
3 short beeps per
second. Engine
overheating pilot lamp
also blinks.
3 short beeps per
second.
150
POSSIBLE CAUSE
Confirms that
proper tether cord
cap is installed.
Engine can rev
above pulley
engagement.
Bad DESS system
connection.
Defective tether
cord cap.
Dirt or snow in
tether cord cap.
Defective DESS
post.
selected.
Wrong tether cord
cap is installed.
Engine is
overheating.
Low battery
voltage.
REMEDY
Normal condition.
Reinstall tether
cord cap correctly
over post.
Use another
programmed tether
cord cap.
Clean tether cord
cap.
Replace DESS
post.
Vehicle can be
driven in reverse.
Install proper tether
cord cap. Program
key into electronic
module.
Stop engine
immediately and
allow to cool.
Check cooling
system.
Check battery and
charging system.
Advertisement
Table of Contents
