Vent System Identification; Special Vent Systems - Empire Comfort Systems DVCT40CSP95N-1 Installation Instructions Manual

Begin the vent system installation by selecting the type of venting
to be installed and the path that it will take. Verify that clearances
are met throughout the path of the venting system.
NOTICE: These fireplaces cannot be vented out the rear.
Determine how the vent system will be terminated out the side of
the house or through the roof. Verify clearances for the termination.
When selecting a vent system for use with the fireplace, refer to the
"Special Vent Systems" section below to determine what systems
are acceptable.
90° ELBOW
OR
45° ELBOW
90° ELBOW
FIRE STOP
WALL STRAP
PIPE LENGTH
GENERIC MODEL SHOWN
The following vent systems are acceptable for use:
• Simpson Duravent ® GS 5 inch x 8 inch
• Selkirk Direct-Temp ® 5 inch x 8 inch
• Security Secure Vent ® 5 inch x 8 inch
• Excel DV Venting 5 inch x 8 inch
• Metal Fab Sure Seal ® 5 inch x 8 inch
– Adapter is required to use this vent
Contact Metal Fab
Page 22

VENT SYSTEM IDENTIFICATION

WALL THIMBLE
CEILING
Figure 32

SPECIAL VENT SYSTEMS

Check all clearances and venting components. Identify if any
problems existing in the vent system.
NOTICE: All outer connection joints must be sealed with aluminum
tape, screws or silicone sealant rated above 300°F/149°C. The inner
flue joints do not require any sealant.
HORIZONTAL TERMINATION
(THREE 90° ELBOWS MAX)
WALL THIMBLE SPACER
(DVCT36 ONLY)
Available From Empire Comfort Systems, Inc. Dealers.
Direct-Vent Fireplace Vent Kit for Rear Vent, 6
to 12 inch wall thickness, Includes 58DVA-06,
DVVK-5RP
58DVA-WT, and 58DVAHC
Direct-Vent Fireplace Vent Kit for Top Vent,
Thru-the-wall, 4 to 6 inch wall thickness,
DVVK-5TP
Includes 58DVA-E90, 58DVA-HC, 58DVA-06,
and 58DVA-WT
Direct Vent Fireplace Vent Kit - Vertical,
DVVK-5VP Includes 58DVA-VCH, 58DVA-SC, and
58DVA-F6
Top Vent Kit (Horizontal) - 4½" to 6" wall
DVVK-5TS
thickness (114.3 mm to 152 mm)
VERTICAL
TERMINATION
(THREE 90°
ELBOWS MAX)
STORM
COLLAR
FLASHING
SPECIAL DV VENT KITS
40651-2-0320