Empire Comfort Systems DVCT40CSP95N-1 Installation Instructions Manual page 32

MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS
Initializing the System for the First Time
1. Remove the wall cover. Remove cover on the wall mounted
battery back-up holder. See Figure 58. Install the four AA
batteries into the wall mounted battery back-up holder then
reinstall the cover. See Figure 59.
2. Install three AAA batteries into the battery bay located on the
base of the transmitter. See Figure 60.
3. Set the wall remote slide switch to the "REMOTE" position.
See Figure 59.
4. Press and release the SWI button on the wall control with
a paper clip and the IFC module will beep three times to
indicate the IFC module is ready to synchronize with the
transmitter within ten seconds. See Figure 59.
Page 32
Figure 58
Figure 59
5. With the batteries already installed in the Transmitter, push
the On button. The Receiver will "beep" four times to indicate
the Transmitter's command is accepted and sets to the par-
ticular code of that Transmitter. The system is now initialized.
Temperature Indication Display °C or °F
With the system in the "OFF" position, press the Thermostat
Button and the Mode Button at the same time. Look at the LCD
screen on the Transmitter to verify that a °C or °F is visible to the
right of the Room Temperature display. See Figures 61 and 62.
Figure 60
Figure 61
Figure 62
40651-2-0320