Empire Comfort Systems DVCT40CSP95N-1 Installation Instructions Manual page 36

MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS
Continuous Pilot/ Intermittent Pilot (CPI/IPI) Selection
With the system in "OFF" position press the Mode Button Figure
3 to index to the CPI mode icon. See Figures 80 and 81.
Pressing the Up Arrow Button will activate the (CPI). Pressing the
Down Arrow Button will return to IPI. A single "beep" will confirm
the reception of the command.
OFF
OFF
Page 36
Figure 80
Figure 81
Button Lock
This function will lock the Buttons to avoid unsupervised operation.
To activate this function, press the MODE and UP Buttons at the
same time. See Figure 82.
To deactivate this function, press the MODE and UP Buttons at
the same time.
OFF
Low Battery Power Detection - Transmitter
The life span of the remote control batteries depends on various
factors: quality of the batteries used, the number of ignitions of
the appliance, the number of changes to the room thermostat set
point, etc.
When the transmitter batteries are low, an Icon will appear on the
LCD display of the transmitter See Figure 83 before all battery pow-
er is lost. When the batteries are replaced this Icon will disappear.
OFF
Figure 82
Figure 83
40651-2-0320