Maintenance And Service - Empire Comfort Systems DVCT40CSP95N-1 Installation Instructions Manual

Glass & Barrier Removal
1. Lift barrier screen and pull towards you.
2. Use the Glass Latch Tool to grip the latch bar and pry
it over the Glass Frame hook flanges. Tilt the Glass
Frame towards you and pull upwards to remove it from
the unit. See Figures 90 and 91.
Glass clips are tightly sprung. If the latch tool slips off of the
latch while pulling, injury may occur. Ensure that the latch
tool is completely hooked around the glass latch before
trying to disengage the glass clips from the glass assembly.
Glass
Latch
(4 Places)
Page 44

MAINTENANCE AND SERVICE

CAUTION
Figure 90
Glass
Latch
Tool
Figure 91
Light Bulb(s) Replacement
1. Remove the following items:
• screen barrier
• glass frame assembly
This unit comes standard with two lights that are attached to the
roof of the fireplace. To access the light bulb you will remove the
following items by removing four screws per light:
• metal bezel
• glass
• gasket
NOTE: Use gloves when handling light bulb, oils on your hand
will diminish the life span of the light bulb.
2. Remove old light bulb and replace with a new one.
See Figure 93.
NOTE: You may order light bulbs from your local Empire dealer
or purchase them from your local hardware store.
LIGHT BULB SPECIFICATIONS
35w Clear Halogen, Bi-Pin 6.35mm base,120vac, UL
Figure 92
Figure 93
See Figure 92.
40651-2-0320