Table of Contents
Advertisement
Begin the vent system installation by selecting the type of venting
to be installed and the path it will take. Verify clearances are met
throughout the path of the venting system.
NOTICE: Some fireplaces cannot be vented out the rear of the
fireplace.
Determine how the vent system will be terminated out the
side of the house or through the roof. Verify clearances for the
termination.
When selecting a vent system for use with the fireplace, refer to
the "Special Vent Systems" section in this manual to determine
90° ELBOW
OR
45° ELBOW
90° ELBOW
CEILING
FIRE STOP
WALL STRAP
PIPE LENGTH
The following vent systems are acceptable for use with the
DVLL60BP90 series fireplaces:
•
Simpson Duravent® GS 5in - 8in
•
American Metal Products 5in - 8in
•
Selkirk Direct-Temp® 5in - 8in
•
Security Secure Vent® 5in - 8in
Page 24
VENT SYSTEM IDENTIFICATION
WALL
THIMBLE
THIMBLE
SPACER
Figure 36
VENT SYSTEMS
what systems are acceptable. Check all clearances and venting
components. Identify if any problems exist in the vent system.
Use Figure 44 on page 27 for top venting to eliminate issues
after installation. Check pipe diameter on vent system and
fireplace to verify the size is the same.
NOTICE: All outer connection joints must be sealed with
aluminum tape, screws or silicone sealant rated above
300°F/149°C. The inner flue joints do not require any sealant.
HORIZONTAL
TERMINATION
(THREE 90°
ELBOWS MAX)
Available from Empire Comfort Systems, Inc. dealers.
DVVK-5RP
DVVK-5TP
DVVK-5VP
DVVK-5TS
DVVK-5F
•
Excel DV Venting 5in - 8in
•
Empire Flexvent Kit DVVK-5F
•
BDM - 5in - 8in
•
Metal Fab 5in - 8in
VERTICAL
TERMINATION
(THREE 90°
ELBOWS MAX)
STORM
COLLAR
FLASHING
SPECIAL DV VENT KITS
Direct-Vent Fireplace Vent Kit for Rear Vent,
6 to 12 inch wall thickness, Includes
58DVA-06, 58DVA-WT, and 58DVAHC
Direct-Vent Fireplace Vent Kit for Top Vent,
Thru-the-wall, 4 to 6 inch wall thickness,
Includes 58DVA-E90, 58DVA-HC, 58DVA-06,
and 58DVA-WT
Direct Vent Fireplace Vent Kit - Vertical,
Includes 58DVA-VCH, 58DVA-SC, and
58DVA-F6
Top Vent Kit (Horizontal) - 4½in to 6in wall
thickness (114.3 mm to 152 mm)
Horizontal Flex Vent Kit (4' Flex) (1.22m)
41368-0-0120
Advertisement
Table of Contents
