Avaya S8500 Job Aid page 11

Figure 2: Removing and replacing the cover on the S8500 media server
Figure notes:
1. Captive screws on media server holding cover in place
Removing the hard drive from the S8500 media server
For these steps, see
1. Locate the drive cage in the left-hand corner of the front of the media server.
2. Use the black pull handles on the ribbon cables to unplug the data connectors from the back
of the CD-ROM and hard drive.
3. Push ribbon cable back out of the way.
4. Unplug the two power connectors from the back of the CD-ROM drive and the hard drive.
You must release the power connector on the CD-ROM drive by gently bending the side
spring clip holding it in place.
5. Loosen the captive screw next to the drive cage.
6. Slide the drive cage toward the back of the media server to clear the retaining hooks.
7. Place the drive cage on the antistatic mat.
d is
c
Figure 3: Removing and replacing the drive cage
Replacing the hard drive
1
h3mscaps LAO 070103
on page 12.
555-245-761 Issue 3 January 2005 11