Cisco UCS E Series Hardware Installation Manual page 58

Installing the NIM E-Series NCE into the Router
Procedure
Step 1
Turn off electrical power to the router. Leave the power cable plugged in to channel ESD voltages to ground.
Step 2 Remove all network cables, including telephone cables, from the rear panel of the router.
Step 3
Align the NIM E-Series NCE with the guides in the chassis walls or slot divider, and slide it gently into the
NIM slot. (See
Figure 29: Installing the NIM E-Series NCE in a Cisco ISR 4000 Series
1 NIM E-Series NCE
Caution
Step 4
Using the faceplate, push the NIM E-Series NCE into place until you feel the NIM seat securely into the
connector on the router backplane. The NIM faceplate should contact the chassis rear panel.
Caution
Step 5 Using a number-1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the NIM faceplate.
What to do next
What to Do Next
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
58
Figure 29: Installing the NIM E-Series NCE in a Cisco ISR 4000 Series, on page
2 Cisco ISR 4000 series
Do not touch the NIM E-Series NCE board. Handle the NIM E-Series NCE by the edges of the
faceplate to reduce the risk of damage to the card.
Do not connect cables to NIM E-Series NCE until you have installed it.
58.)