Cisco UCS E Series Hardware Installation Manual page 27

Servers and network compute engine

Hide thumbs Also See for UCS E Series:

Note

To replace a double-wide E-Series Server with a single-wide E-Series Server or SM E-Series NCE, you must

install a slot divider.

• To install the double-wide E-Series Server, you must remove the slot divider.

Figure 8: Slot Divider for SM Slots

See the following topics for more information:

• "Installing a Slot Divider for Single-Wide E-Series Servers or SM E-Series NCE Installation"

• "Removing the Slot Divider for Double-Wide E-Series Server Installation"

Installing a Slot Divider for Single-Wide E-Series Servers or SM E-Series NCE Installation

By default, the slot dividers are preinstalled in the router. To replace a double-wide E-Series Server with a

single-wide E-Series Server or SM E-Series NCE, you must install a slot divider. Use this procedure to install

a slot divider for a single-wide E-Series Server or a SM E-Series NCE.

Before You Begin

Make sure that you connect the wrist-strap clip to an unpainted portion of the chassis frame to channel unwanted

ESD voltages to ground.

Procedure

Step 1

Remove any installed modules, blank faceplates, and slot adapters from the router slot that you want to use.

Step 2

Insert the top rails of the slot divider between the two guide rails in the top of the module slot.

Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide

Installing a Slot Divider for Single-Wide E-Series Servers or SM E-Series NCE Installation