Cisco UCS E Series Hardware Installation Manual page 44

Servers and network compute engine

Hide thumbs Also See for UCS E Series:

Removing the Memory DIMM

Figure 18: Memory DIMM Location in the Double-Wide E-Series Servers UCS-E180D-M3 and UCS-E1120D-M3

Removing the Memory DIMM

Before You Begin

Make sure that you connect the wrist-strap clip to an unpainted portion of the chassis frame to channel unwanted

ESD voltages to ground.

Procedure

Step 1

Turn off power to the router.

Note

Step 2

Locate the DIMM on the E-Series Server. See the

Step 3

Pull the latches away from the DIMM at both ends to lift the DIMM slightly.

Caution

Step 4

Pull the DIMM out of the socket as shown in the following figure.

Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide

Alternatively, the Cisco 3900 ISR G2 and the Cisco ISR 4000 series support OIR. See the

Insertion and Removal—E-Series Servers, on page

Take care not to dislodge the battery that is adjacent to the DIMM connectors.

34.

Memory DIMM Location, on page

Online

41.