Cisco UCS E Series Hardware Installation Manual page 50

Installing the EHWIC E-Series NCE into the Router
Note The EHWIC slots on both sides of a slot divider must be empty before you remove the slot divider.
Before You Begin
Make sure that you connect the wrist-strap clip to an unpainted portion of the chassis frame to channel unwanted
ESD voltages to ground.
Procedure
Procedure
Step 1 Remove any installed interface cards and blank faceplates from the router slot you plan to use.
Step 2
Loosen the retention screw on the slot divider. See
50.
Figure 24: Cisco ISR G2 EHWIC Slot Divider
1 Retention screws
Step 3 Pull the slot divider straight out of the EHWIC slot.
What to do next
What to Do Next
Install the EHWIC E-Series NCE into the router. See the
on page
Installing the EHWIC E-Series NCE into the Router
The EHWIC E-Series NCE can be installed either before or after mounting the router, whichever is convenient.
Danger Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
50
50.
Figure 24: Cisco ISR G2 EHWIC Slot Divider, on page
Installing the EHWIC E-Series NCE into the Router,