Cisco UCS E Series Hardware Installation Manual page 48

EHWIC E-Series NCE LEDs
1 Memory DIMM slot
3 Hard disk drive (located under the
daughter card)
EHWIC E-Series NCE LEDs
The following table lists the EHWIC E-Series NCE LEDs and describes the LED colors and states.
Table 17: EHWIC E-Series NCE LEDs
LED
Power
SYS
GE Port
LEDs
Basic Workflow for Installing the EHWIC E-Series NCE in the EHWIC Slot
Procedure
Step 1
Step 2
Step 3
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
48
Color State
Green • Steady—CIMC and the CPU are both operating normally.
• Blinking—The CPU is operating normally, and CIMC is booting up.
Amber • Steady—CIMC is operating normally, and the CPU is powered down.
• Blinking—CIMC is in the process of booting up, and the CPU is powered
down.
Green Note Steady—Operation is normal.
If DRAM is not detected, the SYS LED still displays solid green.
Note
• Blinking—System is booting before entering the EFI shell.
Amber Fault is detected on the processor.
Left LED shows the condition of the traffic:
Green
• Blinking—Traffic is detected.
• Off—There is no traffic.
Green Right LED shows whether the link is established:
• Steady—Link is established.
• Off—No link is established.
Command or Action
Reference Topic
Gather the required tools and equipment.
2 SD0
The SD0 card contains the Cisco Integrated
Note
Management Controller (CIMC) software and must
always be present.
4 CMOS battery (located under the daughter card)
Purpose
Action
Tools and Equipment Required for Installation,
on page 25