Cisco UCS E Series Hardware Installation Manual page 33

P0 XXX-XXXX-XX ok 1d01h
P1 Unknown ps, 1d01h
P2 ACS-4450-FANASSY ok 1d01h
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------
0 12090323 12.2(20120829:165313)
1 12090323 12.2(20120829:165313)
2 12090323 12.2(20120829:165313)
R0 12090323 12.2(20120829:165313)
F0 12090323 12.2(20120829:165313)
• To verify that the router recognizes the server, use the show hw-module subslot all oir command:
Router# show hw-module subslot all oir
Module Model Operational Status
------------- -------------------- ------------------------
subslot 0/0 ISR4451-X-4X1GE ok
subslot 1/0 UCS-E140S-M1/K9 ok
subslot 2/0 UCS-E140S-M1/K9 ok
Migrating the E-Series Server from a Cisco ISR G2 into a Cisco ISR 4000 Series
If you are migrating the E-Series Server from a Cisco ISR G2 into a Cisco ISR 4000 series, you must first
upgrade the CIMC and the BIOS firmware image to the latest version—while the E-Series Server is still
installed in the Cisco ISR G2—and then migrate it into the Cisco ISR 4000 series. We strongly recommend
that you upgrade both the CIMC and the BIOS firmware images.
You can use either the Cisco Host Upgrade Utility (HUU) to upgrade the firmware components or you can
upgrade the firmware components manually. For firmware upgrade information, see the "Upgrading Firmware"
chapter in the Getting Started Guide for Cisco UCS E-Series Server Modules and the Cisco UCS E-Series
Network Compute Engine Integrated Management Controller on Cisco.com.
If you migrate the E-Series Server into the Cisco ISR 4000 series without first updating the CIMC firmware,
the E-Series Server might continuously reset. To stop the reset and install the firmware, see the "Stopping the
E-Series Server from Resetting and Updating the CIMC Firmware".
Stopping the E-Series Server from Resetting and Updating the CIMC Firmware
If you migrate the E-Series Server into the Cisco ISR 4000 series without first updating the CIMC firmware,
the E-Series Server might continuously reset. Use this procedure to stop the reset and install the firmware.
Note Some of the steps in this procedure are performed from the router, and other steps are performed from the
E-Series Server.
Procedure
Step 1
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
Migrating the E-Series Server from a Cisco ISR G2 into a Cisco ISR 4000 Series
Command or Action
Router# hw-module subslot slot/subslot
maintenance enable
Purpose
Disables error recovery, which stops the
E-Series Server from being reset.
Note Enter the commands in Step 1 and
Step 2 from the router.
33