Cisco UCS E Series Hardware Installation Manual page 56

NIM E-Series NCE LEDs
1 CMOS battery (located under the daughter card)
3 Memory DIMM slots (located under the
daughter card)
NIM E-Series NCE LEDs
The following table lists the NIM E-Series NCE LEDs and describes the LED colors and states.
Table 18: NIM E-Series NCE LEDs
LED
Power
SYS
IMC
SSD
GE Port
LEDs
Basic Workflow for Installing the NIM E-Series NCE in the NIM Slot
Procedure
Step 1
Step 2
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
56
Color State
Green • Steady—CIMC and the CPU are both operating normally.
• Blinking—The CPU is operating normally, and CIMC is booting up.
Amber • Steady—CIMC is operating normally, and the CPU is powered down.
• Blinking—CIMC is in the process of booting up, and the CPU is powered
down.
Green Note Steady—Operation is normal.
Note If DRAM is not detected, the SYS LED still displays solid green.
• Blinking—System is booting before entering the EFI shell.
Amber Fault is detected on the processor.
Green Blinks when the CIMC is operating normally.
Green Blinks when the SSD is operating normally.
Green Left LED shows the condition of the traffic:
• Blinking—Traffic is detected.
• Off—There is no traffic.
Green Right LED shows whether the link is established:
• Steady—Link is established.
• Off—No link is established.
Command or Action
Reference Topic
2 HDD
4 SD0
Note The SD0 card contains the Cisco Integrated
Management Controller (CIMC) software
and must always be present.
Purpose
Action