Cisco UCS E Series Hardware Installation Manual page 46

Servers and network compute engine

Hide thumbs Also See for UCS E Series:

Installing the Memory DIMM

Procedure

Step 1

Turn off power to the router.

Note

Step 2

Locate the DIMM connector. See the

Note

Step 3

Make sure that both latches on the DIMM connector are in the open position.

Step 4

Orient the DIMM so that the polarization notch on the DIMM lines up with the notch on the connector.

Figure 20: Polarization Notch on the DIMM

Polarization notch

Step 5

Insert the DIMM into the connector.

Step 6

Carefully and firmly press the DIMM into the connector until the latches close onto the DIMM. Make sure

that both latches snap to the closed position against the DIMM.

Figure 21: Installing a Memory DIMM

Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide

Alternatively, the Cisco 3900 ISR G2 and the Cisco ISR 4000 series support OIR. See the

Insertion and Removal—E-Series Servers, on page

Memory DIMM Location, on page

The DIMM connectors on the double-wide E-Series Servers are positioned at an angle; therefore,

make sure that you insert the DIMM at approximately the same angle.

34.

41.

Online