Cisco UCS E Series Hardware Installation Manual page 20

Single-Wide E-Series Server and the SM E-Series NCE LEDs
LED
HDD0 FLT
HDD1 ACT
HDD1 FLT
SYS
Power
GE Port
LEDs
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
20
Color State
Amber The CPU is in use. Fault is detected on the hard drive.
Note The SYS LED displays solid green.
Green Status of the hard drive activity:
• Steady—Hard drive is present.
• Blinking—Active.
• Off—Inactive or there is no power supplied to the CPU.
Amber The CPU is in use. Fault is detected on the hard drive.
The SYS LED displays solid green.
Note
Green Status can be one of the following:
• Solid—Operation is normal.
If DRAM is not detected, the SYS LED still displays solid green.
Note
• Blinking—System is booting before entering the EFI shell.
Amber Fault is detected on the processor.
Status can be one of the following:
Green
• Steady—CIMC and CPU are both operating normally.
• Blinking—CPU is operating normally, and CIMC is booting up.
Amber Status can be one of the following:
• Steady—CIMC is operating normally, and the CPU is powered down.
• Blinking —CIMC is in the process of booting up, and the CPU is powered
down.
Green Left LED shows the speed of the Ethernet cable:
• 1 Blink—10 Mb/s speed.
• 2 Blinks—100 Mb/s speed.
• 3 Blinks—1 Gb/s speed.
Green Right LED shows whether the link is established:
• Steady—Link is established.
• Off—No link is established.