Cisco UCS E Series Hardware Installation Manual page 54

NIM E-Series NCE
Danger
Step 3 After the installation completes, power cycle the router for the new FPGA image to take effect.
Note
NIM E-Series NCE
See the following sections for more information about NIM E-Series NCE:
NIM E-Series NCE Front Panel and Components
The following figure shows the front panel of the NIM E-Series NCE.
Figure 26: Front Panel of the NIM E-Series NCE
1 EN LED
3 Power LED
5 LED for the system
7 GE Port
9 LED for the CIMC
The following figure shows the KVM connector.
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
54
Do not power cycle the router during the FPGA installation process.
If you accidentally lose power during the upgrade process, the FPGA falls back to the factory-installed
image. To ensure proper functionality, you must reinstall the new FPGA image.
2 Management port
4 USB
6 KVM port used for keyboard, video, and mouse (KVM) connector. Refer
27: KVM Connector, on page
8 LED for the SSD drive
55.
Figure