Supply Power And Power Up The System - Dell Networking S3100 Series Getting Started Manual

Supply Power and Power Up the System

Supply power after the switch is mounted in a rack or cabinet.
Dell Networking recommends reinspecting your system prior to powering up.
Verify that:
• The equipment is properly secured to the rack.
• The equipment rack is properly mounted and grounded.
• The ambient temperature around the unit (which may be higher than the
room temperature) is within the limits specified for the system.
• There is sufficient airflow around the unit.
• The input circuits are correctly sized for the loads and that you use
sufficient overcurrent protection devices.
• All protective covers are in place.
CAUTION: ESD damage can occur if the components are mishandled.
Always wear an ESD-preventive wrist or heel ground strap when
handling the system and its components.
Supply power to the system:
• Plug in the AC cord from the switch PSU to the external power source,
such as an AC wall outlet. Make sure that the power cord is secure.
• When the cable is connected between the system and the power source,
the switch is powered up; there is no on/off switch.
16
Installation