Booster Commissioning - Siemens SIPART PS2 Series Operating Instructions Manual

C. Tightening screws
Tighten the screws in the following order.
1. Screws
2. Screws
3. Screws
4. Mount the positioner on the actuator as described in:
– Mounting to linear actuator (Page 40)
– Mounting to part-turn actuator (Page 45)
5. Use the existing interfaces on the booster.
E.3

Booster commissioning

Requirement
1. You operate the positioner with a booster.
2. '51.PNEUM' Pneumatics type (Page 160) parameter is set to 'booSt'.
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE
⑦
which are used to fasten the pressure gauge block
⑫
which are used to fasten the connection block
⑩
which are used to fasten the connection block
E.3 Booster commissioning
⑥
to the positioner
⑨
to the booster
⑨
to the pressure gauge block
Booster
⑥
305