Table of Contents
Advertisement
2.
Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
3.
In the holes where the pins were removed,
install the bolts and washers
4.
Install another washer onto each bolt and secure
with nut (3/4 inch) as shown in
5.
Torque the ROPS pivot bolt to 91 to 113 N∙m
(67 to 83 ft-lb) to avoid any bouncing of the roll
bar and sunshade.
Figure 33
1. Nut (3/4 inch)
2. Roll bar
6.
Position the ROPS-mount bracket onto the top
of the traction unit roll bar
that the roll bar is centered in the ROPS-mount
bracket.
Figure 34
1. Flange nut (1/2 inch)
2. Flange nut (3/8 inch)
7.
Using the mounting holes shown in
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (3-1/2 inches) and 4
flange nuts.
Figure
33.
(Figure
33).
Figure
33.
g215449
3. Washer (13/16 x 1-1/2
inches)
4. Bolt (3/4 x 4 inches)
(Figure
34). Ensure
g246186
3. U-bolt (3-7/8 x 5 inches)
4. Bolt (1/2 x 2-1/2 inch)
Figure
34,
8.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 5 inches) and
2 flange nuts.
1. U-bolt (3-7/8 x 5 inches)
9.
On each side of the sunshade frame, loosely
mount an extension link to the rear and center
holes of the mount bracket with 2 bolts (1/2 x
1-1/2 inches), and 2 flange nuts (1/2 inch) as
shown in
Figure
10.
Attach a brace to the outside of each extension
link with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
36.
1. Flange nut (1/2 inch)
2. Bolt (1/2 x 2-1/2 inches)
3. Extension link
4. Bolt (1/2 x 1-1/2 inch)
14
Figure
Figure 35
2. Flange nut (3/8 inch)
36.
Figure 36
5. Washer (1/2 inch)
6. Brace
7. Brace bracket
35,
g245424
g245195
Advertisement
Table of Contents
