Table of Contents
Advertisement
Preparing the Machine
1.
Park the machine on a level surface.
2.
Lower the cutting units and engage the parking
brake.
3.
Shut off the engine and remove the key.
Note:
Not every machine uses the same parts to
install the kit.
Identifying the U-Bolts
There are 5 different U-bolts included with this kit.
U-bolts are listed by dimension (span x length) in
the parts list. Refer to
dimensions of the U-bolts.
1. Span
Figure 1
to determine the
Figure 1
2. Length
Installing the Sunshade
Groundsmaster 5900 Machine
1.
Position the ROPS-mount bracket onto the top
of the traction unit roll bar
Note:
Make sure that the roll bar is centered
in the mount bracket.
1. Bolt (1/2 x 2-1/2 inch)
2. Flange nut (1/2 inch)
2.
Install the frame assembly to the ROPS-mount
bracket
(Figure
3.
Using the mounting holes shown in
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 4 inches) and
4 flange nuts.
g246183
4.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 4 inches) and
2 flange nuts.
3
(Figure
2).
Figure 2
3. Flange nut (3/8 inch)
4. U-bolt (4-7/8 x 4 inches)
2).
Figure
Figure
g246182
2,
3,
Advertisement
Table of Contents
