Figure 22
1. Flange nut (3/8 inch)
9.
On each side of the sunshade frame, loosely
mount a brace to the sixth hole of the bracket
mount with a bolt (1/2 x 2-3/4 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure
23.
Figure 23
1. Flange nut (1/2 inch)
2. Mounting hole
3. Brace
4. Washer (1/2 inch)
10.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
23.
Note:
The U-bolts are not installed
symmetrically.
g246188
2. U-bolt (3-7/8 x 2-3/4)
g267175
5. Bolt (1/2 x 2-3/4 inches)
6. Brace bracket
7. Bolt (1/2 x 2-1/2 inches)
11.
Move the brace brackets up or down on the
vertical roll bar posts until the sunshade frame
is level to the floor. Use a level to make sure
that the frame is level to the ground. Then,
tighten the U-bolt flange nuts, securing the brace
brackets to the posts.
Note:
Use the front or rear mounting holes,
in the brace bracket, if more adjustability is
required.
12.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
13.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
14.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches) a small washer, and a grommet
24).
15.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
10
Figure
Figure 24
3. Grommet
4. Clip nut
24.
g245151
(Figure