Table of Contents
Advertisement
Figure 3
1. Flange nut (3/8 inch)
5.
On each side of the sunshade frame, loosely
mount a brace to the second hole of the brace
mount with a bolt (1/2 x 2-3/4 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure
4.
Figure 4
Left side shown
1. Flange nut (1/2 inch)
2. Mount hole
3. Washer (1/2 inch)
4. Bolt (1/2 x 2-3/4 inches)
6.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
4.
7.
Move the brace brackets up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor.
Note:
Use a level to make sure that the frame
is level to the ground.
Note:
Use the front or rear mounting holes in
the brace bracket, if you need more adjustability.
8.
Tighten the U-bolt flange nuts, securing the
mounting brackets to the posts.
g246184
2. U-bolt (3-7/8 x 4 inches)
g267172
5. Bolt (1/2 x 2-1/2 inches)
6. Brace bracket
7. Brace
9.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
10.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
11.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet
5).
12.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
4
Figure
Figure 5
3. Grommet
4. Clip nut
5.
g245151
(Figure
Advertisement
Table of Contents
