Table of Contents
Advertisement
4.
On each side of the sunshade frame, loosely
mount a brace to the rear hole of the brace
mount with a bolt (1/2 x 2-3/4 inches), 2 washers
(1/2 inch), and a flange nut (1/2 inch) as shown
in
Figure
40.
Figure 40
1. Flange nut (1/2 inch)
2. Mount hole
3. Washer (1/2 inch)
4. Bolt (1/2 x 2-3/4 inches)
5.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), 2 washers (1/2
inch), and a flange nut (1/2 inch) as shown in
Figure
40.
6.
Move the brace brackets up or down on the
vertical roll bar posts until the sunshade frame is
level to the floor.
Note:
Use a level to ensure that the frame is
level to the ground.
7.
Tighten the U-bolt flange nuts, securing the
mounting brackets to the posts.
8.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84-104 ft-lb).
9.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
g267177
5. Bolt (1/2 x 2-1/2 inches)
6. Brace
7. Brace bracket
Figure
1. Flange-head bolt (5/16 x
2-1/4 inches)
2. Small washer
10.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet
41).
11.
Tighten the sunshade-mounting bolts to 5 to 6
N∙m (45 to 55 in-lb).
Important:
bolts as the sunshade may crack.
41.
16
Figure 41
3. Grommet
4. Clip nut
Do not overtighten the mounting
g245151
(Figure
Advertisement
Table of Contents
