Table of Contents
Advertisement
Installing the Sunshade
Groundsmaster 360 or 7200
Machines
1.
With the roll bar in the raised position, remove
the hairpin cotters and the 2 pins
Figure 19
1. Pin
2. Hairpin cotter
2.
Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
Figure 20
1. Nut (3/4 inch)
2. Roll bar
(Figure
19).
g187726
3. Roll bar (raised position)
4. Roll bar (lowered position)
Figure
20.
g018099
3. Washer (13/16 x 1-1/2
inches)
4. Bolt (3/4 x 4 inches)
3.
In the holes where the pins were removed,
install the bolts and washers
4.
Install another washer onto each bolt and
secure with nuts (3/4 inch) as shown in
20. Torque the nuts 323 to 396 N∙m (238 to 292
ft-lb).
5.
Torque the ROPS pivot bolt
113 N∙m (67 to 83 ft-lb) to avoid any bouncing of
the roll bar and sunshade.
6.
Position the ROPS-mount bracket onto the top
of the traction unit roll bar
Note:
Make sure that the roll bar is centered in
the ROPS-mount bracket.
1. Bolt (1/2 x 2-1/2 inch)
2. Flange nut (1/2 inch)
7.
Using the mounting holes shown in
mount the bracket to the top of the roll bar with 2
U-bolts (4-7/8 x 2-3/4 inch) and 4 flange nuts.
8.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 2-3/4 inches)
and 2 flange nuts.
9
(Figure
20).
(Figure
20) 91 to
(Figure
21).
Figure 21
3. Flange nut (3/8 inch)
4. U-bolt (4-7/8 x 2-3/4 inch)
Figure
Figure
Figure
g246185
21,
22,
Advertisement
Table of Contents
