Table of Contents
Advertisement
Models 30446, 30446N, 30447, and 30447N
1. Flange nut (1/2 inch)
2. Mount hole
3. Washer (1/2 inch)
4. Bolt (1/2 x 2-3/4 inches)
11.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
29.
12.
Move the brace bracket up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor.
Note:
Use a level to make sure that the frame
is level to the ground.
13.
Tighten the U-bolt flange nuts, securing the
mounting brackets to the posts.
14.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
15.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
Figure 30
5. Bolt (1/2 x 2-1/2 inches)
6. Brace
7. Brace bracket
Figure
g267178
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
16.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet
31).
17.
Tighten the sunshade-mounting bolts to 5 to 6
N∙m (45 to 55 in-lb).
Important:
bolts as the sunshade may crack.
Installing the Sunshade
Groundsmaster 4500 and 4700
Machines or Reelmaster 6700 and
7000 Machines
1.
With the roll bar in the raised position, remove
the hairpin cotter and pin.
31.
1. Pin
2. Roll bar
13
Figure 31
3. Grommet
4. Clip nut
Do not overtighten the mounting
Figure 32
3. Hairpin cotter
g245151
(Figure
g215450
Advertisement
Table of Contents
