Toshiba B-SA4TP SERIES Owner's Manual page 75

2.PRINTER SETUP
2.11 Threshold Setting
(Cont.)
<5>SENSOR ADJ.
[PAUSE]
<5>SENSOR ADJ.
[H]28°C [A]28°C
[PAUSE]
<5>SENSOR ADJ.
[REFLECT] 3.5V
[FEED] and [RESTART]
<5>SENSOR ADJ.
[REFLECT] 4.8V*
[PAUSE]
<5>SENSOR ADJ.
[TRANS.] 2.4V
[FEED] and [RESTART]
<5>SENSOR ADJ.
[TRANS.] 4.1V*
[PAUSE]
<5>SENSOR ADJ.
[PE]R0.1VT4.8V
[FEED] and [RESTART]
<5>SENSOR ADJ.
[PE]R0.1VT4.8V*
[PAUSE]
Voltage at a black mark
Midpoint (Threshold voltage)
Voltage at a print area
The Sensor Adjustment Mode contains sub menus for displaying the
current status of each sensor and for storing "media level" voltage and
"no media level" voltage. Each time the [PAUSE] key is pressed, the
sub menus are displayed sequentially.
Sensor Status Display:
Temperatures being detected by the Print Head Thermistor and the
Ambient Thermistor are displayed.
Black Mark Sensor Status Display:
Voltage being detected by the Black Mark Sensor is displayed.
Black Mark Sensor Adjustment:
Using the media actually used, a "media level" voltage is stored.
Feed Gap Sensor Status Display:
Voltage being detected by the Feed Gap Sensor is displayed.
Feed Gap Sensor Adjustment:
Using the media actually used, a "media level" voltage is stored.
Black Mark Sensor/Feed Gap Sensor Status Display (No media):
"No media level" voltage detected by the Black Mark Sensor/Feed Gap
Sensor is displayed.
Black Mark Sensor/Feed Gap Sensor Adjustment (No media):
"No media level" voltage is stored.
When using the Black Mark Sensor
(1) While "<5>SENSOR ADJ." is displayed, press the [PAUSE] key
until the message appears.
The displayed value is a real-time voltage being detected by the Black
Mark Sensor.
(2) Measure a voltage at a blank part of media and a black mark,
respectively. At this time, write down the midpoint between both
voltages. (This value is used later for a threshold setting.)
(Example)
Print area = 4.8V, Black mark = 2.4V
1. When measuring a voltage of a blank area, be careful not to align a
pre-print with the sensor by mistake.
2. Confirm that there is at least 0.7V difference between the two values.
If the difference in voltage is less than 0.7V, a print start position
cannot be detected. In that case, please consider changing the media
type.
3. Make sure that the Top Cover is closed when measuring the voltages.
E2-62
<5>SENSOR ADJ.
[REFLECT] 3.5V
NOTES:
ENGLISH VERSION EO1-33048
2.11 Threshold Setting
Midpoint = 3.6V