Toshiba B-SA4TP SERIES Owner's Manual page 19

2. PRINTER SETUP
2.3 Loading the Media
(Cont.)
NOTE:
Be sure to align the Upper Feed
Gap Sensor with the Lower Feed
Gap Sensor. Failure to do this
cause a paper jam error.
11. After loading the media, it may be necessary to set the position of
the Media Sensor used to detect the print start position for label or
tag printing.
Setting the Feed Gap Sensor position
When using a label stock without black marks, the Feed Gap Sensor is
used to detect a print start position.
(1) Push the Upper Sensor Lever inside and open the Upper Sensor
Ass'y.
(2) Slide the Lower Sensor Tab with your finger to move the Feed Gap
Sensor so that the Feed Gap Sensor is positioned at the centre of the
labels. ( indicates the position of the Feed Gap Sensor).
It may be easier to move the Lower Sensor Tab if you use a pen
inserting its tip into the pinhole of the tab.
It may be easier to move the Lower Sensor Tab if you use a pen
inserting its tip into the pinhole of the tab.
Feed Gap
Sensor
(3) Lower the Upper Sensor Ass'y until the Upper Sensor Lever clicks
into position.
(4) Slide the Upper Sensor Tab to move the Feed Gap Sensor so that it
aligns with the lower Feed Gap Sensor.
Feed Gap
Sensor
E2- 6
ENGLISH VERSION EO1-33048
2.3 Loading the Media
Pinhole
Lower Sensor Tab
Upper Sensor
Tab