Appendix 1 Messages And Leds - Toshiba B-SA4TP SERIES Owner's Manual

APPENDIX 1 MESSAGES AND LEDS

APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
4: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
LCD Message
No.
ON LINE
1
ON LINE
2
HEAD OPEN
3
PAUSE ****
4
COMMS ERROR
5 PAPER JAM ****
6
CUTTER ERROR****
7
NO PAPER ****
8
HEAD OPEN ****
9
HEAD ERROR
10
EXCESS HEAD TEMP
11
RIBBON ERROR****
12
COVER OPEN ****
13
SAVING ####&&&&
14
FLASH WRITE ERR.
15
FORMAT ERROR
16
FLASH CARD FULL
Display of error
17
message (See Note.)
18 POWER FAILURE
19 INTIALIZING...
20 EEPROM ERROR
: The LED is flashing.
LED Indication
ONLINE ERROR
Online mode
Online mode (communicating)
The Top Cover is opened in online mode.
Pause state
A parity, overrun, or framing error has
occurred during a communication by RS-
232C.
A paper jam has occurred during paper
feed.
A problem has occurred at the cutter
module.
The media has run out, or the media is not
loaded properly.
A feed or an issue was attempted with the
Top Cover opened. (Except when the
[FEED] key is pressed.)
The print head has a problem.
The print head is overheated.
• The ribbon has run out.
• The ribbon has been torn. A problem has
occurred with the sensor that determines
the torque for the ribbon motor.
A feed or printing was attempted with the
Front Cover opened.
In writable character or PC command save
mode
An error has occurred in writing to the flash
ROM.
An error has occurred in formatting the
flash ROM.
Saving failed because of an insufficient
capacity of the flash ROM.
A command error has occurred in analyzing
the command.
A momentary power failure has occurred.
The flash ROM is being initialised.
Data cannot be read from/written to a
backup EEPROM properly.
EA1- 1
: The LED is unlit.
Printer Status
ENGLISH VERSION EO1-33048
APPENDIX 1 MESSAGES AND LEDS
Acceptance of
Restoration by
Status Request
RESTART key
Reset Command
Yes/No
Yes/No
----- Yes
----- Yes
----- Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
----- Yes
No Yes
No Yes
No Yes
Yes Yes
No
----- -----
----- -----
No