Care/Handling Of Media And Ribbon - Toshiba B-SA4TP SERIES Owner's Manual

7. SUPPLY SPECIFICATIONS
7.3 Recommended Media and Ribbon Types (Cont.)
Ribbon type
Vellum wax ribbon
Standard wax ribbon
Smear-less ribbon (Wax resin ribbon)
Scratch and solvent resistance ribbon
Combination of Media and Ribbon
Media type
Ribbon type
Vellum wax ribbon
Standard wax ribbon
Smear-less ribbon (wax-
resin ribbon)
Scratch/solvent
resistance ribbon

7.4 Care/Handling of Media and Ribbon

Be sure to carefully review and understand the Supply Manual. Use only media and ribbons that meet
specified requirements. Use of non-specified media and ribbons may shorten the head life and result
in problems with bar code readability or print quality. All media and ribbons should be handled with
care to avoid any damage to the media, ribbons or printer. Read the guidelines in this section
carefully.
• Do not store the media or ribbon for longer than the manufacturer's recommended shelf life.
• Store media rolls on the flat end. Do not store them on the curved sides as this might flatten that side
causing erratic media advance and poor print quality.
• Store the media in plastic bags and always reseal after opening. Unprotected media can get dirty and the
extra abrasion from the dust and dirt particles will shorten the print head life.
• Store the media and ribbon in a cool, dry place. Avoid areas where they would be exposed to direct sunlight,
high temperature, high humidity, dust or gas.
• The thermal paper used for direct thermal printing must not have specifications which exceed Na
+
K 250 ppm and Cl
• Some ink used on pre-printed media may contain ingredients which shorten the print head's product life. Do
not use labels pre-printed with ink which contain hard substances such as carbonic calcium (CaCO
kaolin (Al O , 2SiO
2 3
For further information, please contact your local distributor or your media and ribbon manufacturers.
This ribbon is mainly used for vellum paper and labels. It has a very
high ink density to cope with uneven printing surface
Good match for coated paper (Matt coat and glossy coat).
Good match for coated paper. The printed image will resist water and
light rubbing.
Very good match for plastic films (synthetic paper, PET, polyimide,
etc.)
Scratch and solvent resistance
Heat resistance with PET and polyimide.
Vellum paper and label
-
500 ppm.
, 2H O).
2 2
Description
Coated paper
CAUTION!
E7- 5
ENGLISH VERSION EO1-33048
7.4 Care/Handling of Media and Ribbon
Plastic films
: Good match
+
800 ppm,
) and
3